Page 2
Model 9610 Dispenser Mechanism Installation PURPOSE INSTALLATION PROCEDURE The following procedure assumes you are installing a Model 9610 dispensing mechanism into a Model 9600 1. Open the ATM control panel and ensure the power ATM chassis. switch (on the power supply panel) is set to the OFF (0) position.
Page 3
Model 9610 Dispenser Mechanism Installation Attach the dispenser to the tray with two screws on each side. 5. Place the cable clip over the DC Dispenser Power The cables should be routed through the back slide Cable and the EJ-to-Dispenser (Data) cable. Attach rail as shown.
Need help?
Do you have a question about the Triton 9610 and is the answer not in the manual?
Questions and answers