Advertisement
Main Light = Service / Warning Indicator:
Requirements for a service and user warnings are indicated
after operation by the main light repeatable ashing OFF a
number of times followed by a pause.
The below table identi es the issues and remedies
1
Normal operation (door is fully open)
PE is precenting door
2
from moving
Wireless Auto-Lock
3
battery is low
4
Wireless PE battery is low
5
Wireless Auto-Lock is not
unlocked and preventing
door moving
Maintenance is due after
6
pre-set number of cycles.
7
Standby battery is faulty
Door was obstructed
8
9
Motor overloaded or
stalled
10
Unit running on battery
power (Only available
with SDO-7 & SDO-9
6 . 0 T R O U B L E S H O O T I N G
Issue
Remedy
Clear away any obstructions.
Test Door. If unable to move
the door and suspect beam
is faulty, enter Safety Beam
Emergency Close by
pressing and holding a
pre-coded transmitter button
until the door closes.
Change Auto-lock battery
Change PE Battery
Check Auto-Lock, test by
pressing emergency release
button on the lock and the
test door operation.
Contact dealer to arrange
service.
Contact 1300 769 850 within
Australia for assistance.
Clear away any obstructions
and test door opens/closes
correctly. (if the door is
damaged, contact a door
professional)
Contact dealer to arrange a
door service.
Main light will ash (3) three
times at the start of the cycle
to indicate the opener is
running from battery backup
and 10 ashes at the end of
cycle. Check power supply.
Advertisement
