Gastroback DESIGN MULTI JUICER DIGITAL Operating Instructions Manual page 48

Problem Reason
Liquids run over the The juice collector
rim of the motor or juice spout is
base and/or are blocked.
accumulating under
the motor base.
The pulp container is
overfilled.
The juicing sieve is
overfilled.
Juice sprays out and Some juices are
splashes at the juice very frothy, causing
spout. splashing at the jui-
ce spout.
The drip-stop is not
completely open.
48
The Solution
Immediately unplug the appliance. Clean and dry the appliance
(see: 'Cleaning the Juicing System') and leave the motor base
dry naturally for 1 day.
Always ensure to turn the drip-stop at the juice spout of the
juice collector open before juicing (see: 'Drip-Stop Feature').
Check the juice collector for any obstacles (see: 'Emptying the
Containers and Removing Obstacles').
Immediately unplug the appliance. Clean and dry the appliance
(see: 'Cleaning the Juicing System') and leave the motor base
dry naturally for 1 day.
Do not overfill the pulp container or juice jug during processing
(see: 'Emptying the Containers and Removing Obstacles').
Immediately unplug the appliance. Clean and dry the appliance
(see: 'Cleaning the Juicing System') and leave the motor base
dry naturally for 1 day.
Do not overfill the feed chute. Do apply too much pressure onto
the food pusher during juicing (see: 'Emptying the Containers
and Removing Obstacles' and 'Method of Operation and Making
Breaks').
Do not apply too much pressure. If possible, process this type of
food in combination with other foodstuffs.
Ensure to open the drip-stop by turning the stainless steel sleeve
at the juice spout (see: 'Drip-Stop Feature').