Gastroback DESIGN MULTI JUICER DIGITAL Operating Instructions Manual page 46

Problem Reason
The motor base gets The power cord is
unexpectedly hot still wound partly
during operation. around the cord
storage during ope-
ration.
The motor is already
running continuously
for a too long time.
Malfunction has
occurred.
The motor stops Too much too hard
unexpectedly during or fibrous food in
operation. the processing sys-
tem is blocking the
knives.
The overheat protec-
tion device has been
triggered.
The electronic over-
load protection has
been triggered.
After leaving the
appliance operate
for more then 20
minutes, the auto-
matic shut-off has
been triggered.
46
The Solution
Always unwind the power cord completely before operation to
avoid overheating (see: 'Before First Use').
Do not let the appliance operate continuously for more than 20
minutes. With heavy load, make a break after each 7 minutes
(see: 'Method of Operation and Making Breaks'). If required,
process your food in portions.
Immediately unplug the appliance. Get in contact with an autho-
rised service centre for examination and repair.
Immediately switch off (selection dial to "OFF", power switch
to "O") and unplug (see: 'Electronic Overload Protection').
Remove the obstacle (see: 'Emptying the Containers and Remo-
ving Obstacles' or 'Removing Obstacles from the Glass Jugs').
Thereafter, try again.
Immediately switch off (selection dial to "OFF", power switch
to "O") and unplug. Leave the appliance cool down for at least
30 minutes (see: 'Self-Resetting Overheat Protection Device').
Thereafter, try again.
Immediately switch off (selection dial to "OFF", power switch
to "O") and unplug (see: 'Electronic Overload Protection').
Remove the obstacle (see: 'Emptying the Containers and Remo-
ving Obstacles' and 'Removing Obstacles from the Glass Jugs').
Thereafter, try again.
Simply turn the selection dial to another speed selection to re-
activate the appliance (see: 'Automatic Shut-Off'). However,
you should make a break of at least 20 minutes: switch "OFF"
the appliance completely (at the selection dial and power
switch). Then unplug the appliance and wait for the appliance
to cool down.