Gastroback DESIGN MULTI JUICER DIGITAL Operating Instructions Manual page 44

SOLVING PROBLEMS
Many problems occurring during operation may be solved easily by observing the
hints, given in 'Properties of Your New Multi Juicer', 'Tips for Best Results' and 'Ope-
ration'. Additionally, you will find solutions in the following table.
Problem Reason
The display stays The appliance is not
dark and the motor live.
does not move, alt-
hough a speed is
The power switch at
selected.
the rear of the appli-
ance is switched to
"O" (off).
The automatic shut-
off is active.
During operation, a This may occur duri-
slightly burnt smell ng the first run of
is escaping from the the motor and usu-
appliance. ally stop after some
time of operation.
During operation,
loops of the power
cord have been still
wound around the
cord storage at the
bottom of the motor
base.
Liquids ran into the
motor base.
The motor is over-
heated.
44
The Solution
Check, if the power plug is inserted in an appropriate wall
power outlet and the used power outlet is live (connect a
lamp).
First turn the selection dial to "OFF". Then switch the power
switch at the rear of the appliance to position "I". Try again.
After 20 minutes or more in operational mode (switched on
with a speed selected), the automatic shut-off is activated (see:
'Automatic Shut-Off'). Simply select another speed for re-acti-
vating the appliance.
There is no need for concern. However, if the problem persists
even after repeated usage, get in contact with an authorized
service centre.
Immediately unplug the appliance. Always unwind the power
cord completely (approx. 110cm) to avoid overheating. Check
the complete power cord for damage (e.g. molten or brittle
parts, discolouration). If in doubt, get in contact with an authori-
sed service centre for examination and repair.
Immediately switch off (selection dial to "OFF", power switch
to "O") and unplug. Clean the appliance and leave the appli-
ance dry naturally for at least 1 day. If the problem persists, get
in contact with an authorized service centre.
Leave the appliance cool down for at least 1/2 hour.