Turning On/Off The Power - Roland V-DRUMS TD-20 Owner's Manual

Percussion sound module
Hide thumbs Also See for V-DRUMS TD-20:
Table of Contents

Advertisement

Setting Up the Kit

Turning On/Off the Power

941
* Once the connections have been completed (p. 18, p. 19), turn
on power to your various devices in the order specified. By
turning on devices in the wrong order, you risk causing
malfunction and/or damage to speakers and other devices.
fig.VolMin
1. Turn the [MASTER] and [PHONES] completely
to the left to lower the volume to "0."
2. Turn down the volume control on the
connected amp or audio system.
3. Push the [POWER] switch on the TD-20's rear
panel to turn on the power.
fig.PowerOn.e
942
* This unit is equipped with a protection circuit. A brief interval
(a few seconds) after power up is required before the unit will
operate normally.
Precautions When Turning on the
Power
After the power is turned on, do NOT hit any pads or
step on the pedals until the drum kit name (following
figure) appears in the display. Doing so can cause
triggering problems.
fig.00-006
4. Turn on the power to the connected amp or
audio system.
5. While hitting a pad, gradually turn [MASTER]
(or [PHONES]) to the right to adjust the volume
level.
20
Lower Position
ON
No Sound When Hitting the Pads or Using the
Pedals?
Check the following points.
When Using an Amp or Audio System
• Is the amp or audio system connected to the TD-20's
MASTER OUT jacks?
• Is the input of the amp or audio system properly
connected?
• Is there a problem with any connection cables?
• Is the volume turned down in the [GROUP
FADERS] sliders?
• Is [MASTER] turned completely to the left?
• Have the input select settings of your audio system
or amp been made correctly?
• Is the amp or audio system volume setting correct?
When Using Headphones
• Are the headphones connected to the PHONES jack?
• Is [PHONES] turned completely to the left?
Turning Off the Power
1. Completely turn down the volume of the TD-20
and any connected external devices.
2. Turn off the power to all external devices.
3. Push the [POWER] switch on the TD-20's rear
panel to turn off the power.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents