Turning The Power On/Off; Saving Your Settings - Roland TD-4KP Owner's Manual

Turning the Power On/Off

Once everything is properly connected (p. 8), be sure to follow the procedure below to turn on their power. If you turn on equipment in
the wrong order, you risk causing malfunction or equipment failure.
fig.P-PowerOn.eps
3
1
1. Turn the [VOLUME] knob all the way to the left.
2. Minimize the volume of the connected amp or
audio system.
3. Press the [POWER] button.
* Before turning the unit on/off, always be sure to turn the
volume down. Even with the volume turned down, you might
hear some sound when switching the unit on/off. However,
this is normal and does not indicate a malfunction.
* This unit is equipped with a protection circuit. A brief interval
(a few seconds) after turning the unit on is required before it
will operate normally.
Caution when Turning On the Power
After you turn on the power, do NOT touch any pads or
pedals until the drum kit name (the illustration below) has
appeared in the display. Doing so can cause various
problems.
ig.d-OpenKitNo1.eps
4. Power-on the connected amp or audio system.
5. While hitting a pad, gradually turn the [VOLUME]
knob toward the right to adjust the volume.
Adjust the volume of the connected amp/ audio system to
the desired level.
If you don't hear any sound
Check the following points.
Pad and Pedal Connections
• Is the cable correctly connected to the TRIGGER INPUT
connector?
• Are the cables correctly connected to each pad or
pedal?
When Using an Amp or Audio System
• Are the TD-4's OUTPUT jacks connected correctly to the
input jacks of your amp/audio system?
• Are the input selections and volume settings correct on
that amp/audio system?
• Possible problem with the connection cables
themselves?
• Isn't the [VOLUME] knob turned all the way to the left?
• Have the input select settings of your audio system or
amp been made correctly?
• Is the amp or audio system volume setting correct?
When using headphones
• Are your headphones plugged into PHONES jack?
• Isn't the [VOLUME] knob turned all the way to the left?
Turning the Power Off
1. Turn the volume down on the TD-4 and any
connected equipment.
2. Power-off the connected equipment.
3. Hold down the [POWER] button until the display
indicates "See you!"

Saving Your Settings

The TD-4 does not have a specific "operation" for saving your
settings. Any changes you've made will be saved when you turn
off the power.
* You must turn off the power by pressing the [POWER] button.
Getting Ready to Play
9