Roland V-DRUMS TD-20 Owner's Manual page 42

Chapter 4. Effect Settings
FLANGER
Produces a metallic resonance that rises and falls somewhat
like a jet airplane taking off or landing.
Parameter Value
Delay 0–15.0 (ms)
LFO Rate 1–128
Depth 0–127
Feedback -98–98 (%)
Phase 0–180
PHASER
Adds a phase-shifted sound to the original sound, producing
a swirling modulation.
Parameter Value
Freq 100–8000 (Hz)
LFO Rate 1–128
Depth 0–127
Resonance 0–127
CHORUS
Gives richness and spaciousness to the sound.
Parameter Value
Delay 8.0–30.0 (ms)
LFO Rate 1–128
Depth 0–127
Phase 0–180
ENHANCER
Controls the overtone structure of the high frequencies,
adding sparkle and brightness to the sound.
Parameter Value
Sens 0–127
LF Level 0–127
42
Description
Tone of the flanger
Frequency of modulation
Depth of modulation
Amount of the flanger
sound that is fed back into
the effect (minus: inverts
the phase)
Spatial spread of the
sound
Description
Basic frequency at which
the sound will be modu-
lated
Frequency of modulation
Depth of modulation
Amount of feedback
Description
Tone of the chorus
Frequency of modulation
Depth of modulation
Spatial spread of the
sound
Description
Sensitivity of the enhancer
Volume level of the low
frequency range of the di-
rect sound
PITCH SHIFT
Shifts the pitch of the original sound.
Parameter Value
Mode 1–5
Delay 0–100.0 (ms)
Coarse -24–12
Fine -100–100
Feedback -98–98 (%)
OVERDRIVE
Creates a soft distortion similar to that produced by vacuum
tube amplifiers.
Parameter Value
Drive 0–127
HF Level 0–127
LF Bypass OFF, ON
Expanse OFF, ON
DISTORTION
Produces a more intense distortion than Overdrive.
Parameter Value
Gain 0–127
HF Level 0–127
LF Bypass OFF, ON
Expanse OFF, ON
Description
Setting a higher value re-
sults in a slower response,
but steadier pitch.
Time until the pitch-shift-
ed sound is heard
Amount of pitch shift
(semitone steps)
Amount of pitch shift (2-
cent steps)
Amount of the pitch-shift-
ed sound that is fed back
into the effect (minus: in-
verts the phase)
Description
Amount of distortion
Level of high frequency
range
Bypass for the low fre-
quency range
When this is set to
"OFF," the low frequen-
cy range also has a dis-
tortion sound.
Adding the spatial spread
of the sound
Description
Amount of distortion
Level of high frequency
range
Bypass for the low fre-
quency range
When this is set to
"OFF," the low frequen-
cy range also has a dis-
tortion sound.
Adding the spatial spread
of the sound