Installing The System Hardware; Basic System Installation; Optional) Connecting A Ups; Optional) Connecting The Usb Lcm - Qsan XCubeSAN 3300 Hardware Manual

3. I
NSTALLING THE
This chapter will guide you through the installation process.

3.1. Basic System Installation

For basic system installation, please refer to the
downloaded from the website. You can learn to install the disk drives, optional host cards, rail
kits, and power on the storage system to discover and setup the system.
For more information about discovering your system and the initial configuration, please refer
to the XEVO Software

3.2. (Optional) Connecting a UPS

If users want to install a UPS (uninterruptible power supply) to provide clean power and offer
protection against mains power failures, please follow the following instructions.
1. Before you purchase a UPS system, please check the supported UPS interfaces and
communication types.
2. Supported types  UPS via SNMP, Serial UPS with COM port, and USB UPS.
3. Communication types  network UPS via SNMP, Serial UPS with COM port, and USB UPS.
Serial communication is the only supported type.
4. Connect the UPS to the system via Service Port (UPS).

3.3. (Optional) Connecting the USB LCM

If you purchased the USB LCM, please use the enclosed USB extension cable (A-male to A-
female) to connect to the system. The Following procedures are for the USB LCM connection:
1. Connect the USB LCM to the female side of the USB extension cable.
2. Connect the male side of the USB extension cable to the USB port on the system front pillar.

Installing the System Hardware

29
© 2022 QSAN Technology, Inc. All rights reserved.
www.qsan.com
S
YSTEM
Manual.
H
ARDWARE
XS3300 Quick Installation Guide
XCubeSAN 3300
Hardware Manual
which can be
Official
Document