Qsan XCubeFAS 3126D Quick Installation Manual

XCubeFAS 3126D Quick Installation Guide
1 BEFORE YOU BEGIN
Package Contents
A QSAN storage system includes:
System Chassis (x1)
3U 26-bay
AC Power Cords (x2) RS-232 Console Cable (x2)
2 INSTALL SOLID-STATE DRIVES
Unlock the Tray
1. The standard position of the tray is locked to prevent damage
during transport.
2. To unlock the tray: shift the release button lock from left to right.
Open the Carrier Handle of the Tray
1. The procedure of opening the tray carrier handle: shift the
carrier handle release button from up to down; then carrier handle
will automatically pop out.
Install an SSD into the Tray
1. Place the tray onto a stable surface.
2. Remove the supporting bracket. Then align the SSD with the
connector facing away from the carrier handle.
3. Align the four tray screw holes on both sides of the disk tray.
4. Install and tighten all four screws to secure SSD within the tray.
Install the Tray with the SSD into the System Chassis
1. Users must open the carrier handle of the tray before
installing it into the empty bay of the system chassis.
2. Align an SSD with the tray to the empty bay you would like
to install, and push it all the way into the disk drive bay until
the carrier handle can be closed.
3. Lock the release button lock by pushing the lock from right to
left.
4. Refer to the label on the system chassis for the disk numbering.
The disk numbering for system is printed on the chassis.
3
INSTALL THE OPTIONAL HOST CARDS
Please refer to the QSAN XF3126D hardware manual for detailed instructions.
1. Remove the dummy host card cage by loosening two screws of the dummy host card cage.
2. Align the host card to the slot to be installed and use two screws that lossing from dummy host card cage
to fasten on the controller.
3. Repeat procedures above if there are other host cards need to be installed.
Thank you for purchasing QSAN XF3126D storage system.
Disk Drive Trays Slide Rail Kit (x1)
(x26 SFF ) for 3U 26-bay
1
Screws Pack for Disk Drives
Optional Accessories
You can check the optional accessories on QSAN website :
https://www.qsan.com
Prepare System Information for Installation
- System name
- Admin password
- NTP server address
- Management IP address
- DNS server address
More Information
For additional hardware manual, software manual, or compatibility
matrix which includes HDD, SSD, HBA, and switch requirements,
please refer to the QSAN download center.
SFF : Small Form Factor / 2.5" disk drive
1
XF3126D only supports QSAN SD4 SSD.
Carrier Handle
Release Button
Unlock
Direction Release Direction
SFF Tray
1
Unlock Direction
Supporting Bracket
(* Remove for
Disk Insertion)
2
Release Button Lock
1
2