Optional) Host Cards; Table 2-13 Descriptions Of The Flash Module Leds And Button - Qsan XCubeSAN 3300 Hardware Manual

NUMBER
1 Power LED
2 Status LED
3 Attention Button
CAUTION
The flash module of Cache-to-Flash is hot swappable because it is a PCIe
device. Before removing the flash module from the system chassis, you must
press the attention button until the flash module status LED finished
blinking. Otherwise, the flash module maybe damage.

2.6. (Optional) Host Cards

The system comes with four on-board 10GbE iSCSI ports on each controller. If you want to
expand the number of host ports, purchase QSAN host cards (optional components) will be the
fastest and most cost-efficiency choice.
There are several types of host cards that are available for selection. You can configure a Fibre
Channel by using QSAN 32/16Gb Fibre Channel host cards; you can choose an iSCSI by using
25/10GbE via SFP28/SFP+ or 10GBASE-T host cards. Following figure is the overview of the host
card installation slots.
System Components Overview
21
© 2022 QSAN Technology, Inc. All rights reserved.
www.qsan.com

Table 2-13 Descriptions of the Flash Module LEDs and Button

DESCRIPTION





Used to prompt system that the flash module
can be removed later.
DEFINITION
Solid Green: Power is good at flash module.
Off: There is no power at flash module.
Solid Blue: The status of flash module is
good.
Blinking Blue and Amber
or removing the flash module.
Solid Amber: The flash module is failed or
wrong PCIe connection speed.
XCubeSAN 3300
Hardware Manual
Interlaced: Installing
Official
Document