Table of Contents
Advertisement
3.1.2.1 Shut down the scan head
1. End the current session and select
2. Wait for the status indicator to turn yellow and then switch off the scan head power. The touch screen
will switch off when the device is switched off.
3. Fit the dust cap in the eye piece and place the fabric cover over the scan head.
3.1.2.2 Install software updates
Each time you shut down the system the device will check for software updates. You should follow the
instructions displayed on the touch screen to start the software update.
The device shuts down when the updates have completed.
3.1.2.3 Log off the image server each day
You should log off the image server at the end of each day.
1. Exit OptosAdvance.
2. Select the "Windows" button.
3. Select
Log
off.
Note
Your device communicates with Optos overnight and will need to access the image server PC.
l
Image files cannot be viewed on browser-based review clients when the image server has been
l
shut down.
Restart the image server each week to allow updates to install, see Restart the image server each
l
week below.
3.1.2.4 Restart the image server each week
Exit
OptosAdvance
CAUTION
You should restart the image server each week to allow updates to install.
1. Exit OptosAdvance.
2. Select the "Windows" button.
3. Select Restart.
3.1.3 Use the system
Before setting up and capturing images, ensure you are familiar with the device and equipment.
3.1.3.1 Using the touch screen
The touch screen is connected to the scan head and controls the scan head and capture functionality.
The options are selected by touching an option or pushing the control in the required direction.
Part Number: G102748/11_ENG
Copyright 2021, Optos plc. All rights reserved.
on the touch screen to close the device.
before turning
the image server.
OFF
Chapter 3 - How to...
Page 29 of 60
English
Advertisement
Table of Contents
