Watchdog Timer; Low-Voltage Detection; P0, P1 Port Pullup - Renesas MCU Board for PC4504 Emulator System M34570T-MCU User Manual

5.4 Watchdog Timer

The M34570T-MCU does not have an operational watchdog timer. Therefore, use an evaluation
MCU (OTP version) to verify the operation associated with a watchdog timer.
The M34570T-MCU outputs a signal whose waveform is shown below from the check pin TP5
during WRST instruction execution cycles. This signal allows you to check the initialization cycle
of a watchdog timer.
Figure 5.1 Waveform output from check pin TP5

5.5 Low-voltage Detection

Because the power to the evaluation MCU of M34570T-MCU is supplied from the M34570T-MCU,
low-voltage cannot be detected. To evaluate the operation associated with low-voltage detection, use
an evaluation MCU (OTP version).

5.6 P0, P1 Port Pullup

Port P0 and P1's (M34570T-MCU) resistance value of the pullup register is 68kΩ.
System clock
X
IN
WRST
WRST instruction
( 24 / 34 )
Next WRST instruction