Advertisement
QRS PMII to PNO3WB Upgrade Instruc ons
PianoDisc
The PianoDisc controller is not needed to play the piano from PNO3WB processor.
The PianoDisc controller IS needed to calibrate the keys and pedal solenoid.
IF the PianoDisc controller is removed, do not discard, it can be reconnected to calibrate the system.
Locate the PianoDisc's CPU Interface on the back side of the key solenoid rail.
Connect the MIDI cable from the MIDI OUT of the PNO3WB processor to the MIDI IN of the PianoDisc.
Disklavier
Connect the MIDI cable from the MIDI OUT of the PNO3WB processor to the MIDI IN of the Disklavier.
On the back of the Disklavier controller set the
Some units may not have the HOST SELECT switch and you may have to make a change in the controller's setup menu.
Record system
, connects to the MIDI IN, if installed.
Power Adapter
The PNO3WB processor will begin to power ON as soon as it is connected to power.
Turn on the PianoDisc or Disklavier.
Connect the power adapter into the 9VDC jack on the end of the PNO3WB processor.
Connect the power adapter to an AC outlet.
MIDI Controller
HOST SELECT
switch to "MIDI".
PDS128 Plus
CPU Interface
Disklavier Mark
III Controller
PNO3 Power Adapter
AC outlet
9 Volts DC / 2 Amps
Center Posi ve
5
Advertisement
