Advertisement
QRS PMII to PNO3WB Upgrade Instruc ons
If you did NOT connected a ribbon cable to the PNOscan 10 port on the PNO
PNOscan Key Adjust
This procedure calibrates the PNOscan's key sensors and saves the data to the PNO
Go to: System Setup / Record Setup / PNOscan Adjust / PNOscan Keys Basic / Press the "Reset Calibra on" bu on.
The "PNOscan Key Adjustment" dialog box appears.
Press and hold the first bass key.
When you hear the sound of the note from the speaker, release the key.
The fi h light on the PLxMV box should blink.
Repeat for all 88 keys and Press "OK" when finished.
PNOscan Pedal Adjust
Go to: System Setup / Record Setup / PNOscan Adjust / PNOscan Pedals
The pedal sensors will not work if the Pedal Trigger number is not between the Rest and Down numbers.
Sustain Pedal
Tap the "Rest" bu on and wait for the "Rest" number to change value.
Depress the Sustain Pedal to the floor.
Tap the "Down" bu on and wait for the "Down" number to change value.
Release the Sustain Pedal.
Slowly depress the Sustain Pedal while tapping a piano key.
When the tone rings, indica ng that the dampers have li ed off of the strings.
Tap the "Trigger" bu on and wait for the Trigger number to change value.
Release the Sustain pedal
So Pedal [Only func onal when using computer so ware to record songs.]
Tap the "Rest" bu on and wait for the "Rest" number to change value.
Depress the So Pedal to the floor.
Tap the "Down" bu on and wait for the "Down" number to change value.
Tap the "Trigger" bu on and wait for the "Trigger" number to change value.
Release the pedal.
Sostenuto Pedal ‐ No adjustment necessary.
Go to: Play Piano / Genre / Country & Western Accompaniment
Tap the song name,
Deed I
QRS PNOscan Record Setup, If Installed
Audio Accompaniment‐Speaker Test
Do. The audio should start right away.
3
processor then skip this page.
3
processor.
11
Advertisement
