Advertisement
Two important se ngs:
1] The PIANO CURVE se ng on the So Playback pages should ALWAYS be set to 0.
If it's greater than zero then, it's overridden the key adjust se ngs and will not play as so ly as possible.
2] Each of the Master Volume Curves has three pages; So Playback, Full Expression and Loud Playback. So Playback
needs to be lower than Full Expression which needs to be lower than Loud Playback. If not...say the Full Expression se ng is higher
than Loud Playback...you won't have ANY volume control as you play the piano.
Master Volume Curves –
Go to: System Setup / Performance Setup / Master Volume Curves
Tap the QRS Solo File Setup [Songs with red tles]
Volume Curve Configura on – So Playback page
Set the PLAYBACK QRS (SOLO) PIANO CURVE = 0
Tap NEXT to Volume Curve Configura on – Full Expression Playback page
Set the PLAYBACK QRS (SOLO) PIANO CURVE = 50
Tap NEXT to go to the Volume Curve Configura on – Loud Playback page
Set the PLAYBACK QRS (SOLO) PIANO CURVE = 90‐100
Tap Finish
Tap the QRS Audio File Setup [Songs with blue tles]
Volume Curve Configura on – So Playback page
Set the PLAYBACK QRS/MP3 AUDIO CURVE = 0 to 10
Set the PLAYBACK QRS/MP3 PIANO CURVE = 0
Tap NEXT to the Volume Curve Configura on – Full Expression Playback page
Set the PLAYBACK QRS/MP3 AUDIO CURVE = 100
Set the PLAYBACK QRS/MP3 PIANO CURVE = 50
Tap NEXT to go to the Volume Curve Configura on – Loud Playback page
Set the PLAYBACK QRS/MP3 AUDIO CURVE = 190‐200
Set the PLAYBACK QRS/MP3 PIANO CURVE = 90‐100
Tap Finish
These Prompt se ngs control the announcements only and not the music audio.
Turn OFF at Night:
System Setup / Clock Setup / Clock
Quiet Prompt Start (Hour) Default is 20...8PM
Quiet Prompt Length (Hours) Default is ‐1...prompts are on all hours
Se ng the Length to 12 will mute the prompts from 8PM to 8AM
Turn OFF Completely:
Go to: System Setup / Network Se ngs / Network Advanced
...(Select to Enable)...turns voice announcements ON
Lower volume:
Go To: System Setup / Performance Setup / Master Volume Curves
Tap the Voice Prompt Setup bu on to the Volume Curve Configura on – So Playback page
Set the Voice Volume Default slider to 2
Tap NEXT to go to the Volume Curve Configura on – Full Expression Playback page
Set the Voice Volume Default slider to 6
Tap NEXT to go to the Volume Curve Configura on – Loud Playback page
Set the Voice Volume Default slider to 10
Tap Finish
12
QRS PMII to PNO3WB Upgrade Instruc ons
Master Volume Curves
The Mute Piano & Synth bu ons
only apply if the Play Sample is used.
Voice Prompts
Advertisement
