NordicTrack T 8.0 User Manual page 13

14. Set the console assembly on the Right Upright
(82) and the Left Upright (not shown). Be care-
ful not to pinch any wires.
Start four 5/16" x 1" Bolts (5), and four 5/16"
Star Washers (12), and two 5/16" x 1 1/4" Bolts
(4) into the Right Upright (82) and the Left
Upright (only one side is shown); start all six
Bolts, and then tighten each of them.
Tighten the plastic tie around the console wire
and cut off the end of the tie.
Tighten all eight of the 1/4" x 3/4" Bolts (3) (four
are shown).
15. Position the Right Outside Upright Cover (84)
and the Right Inside Upright Cover (83) against
the Right Upright (82) as shown. Attach the
Covers with two #8 x 3/4" Screws (1).
Attach the Left Outside Upright Cover and
Left Inside Upright Cover to the Left Upright
(not shown) as described above.
See steps 4 and 6. Tighten the four 3/8" x
4 1/4" Bolts (6) and the two 3/8" x 1 1/2" Bolts
(7).
Console
14
Assembly
Plastic Tie
Console
Wire
3
4
3
82
15
Console
Assembly
84
13
5
12
1
83
82