NordicTrack T 8.0 User Manual page 12

11. Position the console wire under the Handrail
Crossbar (74) as you set the Right Handrail (77)
onto the console assembly. Be careful not to
pinch the console wire.
Attach the Right Handrail (77) to the console as-
sembly with a #8 x 3/4" Screw (1), four 1/4" x
3/4" Bolts (3), and four 1/4" Star Washers (11);
Start all four Bolts, but do not tighten them
yet. Tighten the Screw.
Attach the Left Handrail (not shown) in the same
way. Note: There is not a wire on the left side.
12. Tighten the eight #8 x 3/4" Screws (1). Be care-
ful not to overtighten the Screws.
13. Remove the plastic ties from the 5/16" Cage
Nuts (34) (only one side is shown). If needed,
press the Cage Nuts back into place.
With the help of a second person, hold the con-
sole assembly near the Right Upright (82) and
the Left Upright (not shown).
Connect the Upright Wire (85) to the console
wire. See the inset drawing in step 8. The
connectors should slide together easily and
snap into place. If they do not, turn one connec-
tor and try again. IF YOU DO NOT CONNECT
THE CONNECTORS PROPERLY, THE CON-
SOLE MAY BECOME DAMAGED WHEN YOU
TURN ON THE POWER. Remove the wire ties
from the wires.
11
3
11
74
Console
Wire
12
1
1
13
Console
Assembly
Wire
Tie
34
85
82
12
Console
1
3
11
Console
Assembly
1
1
Console
Wire
Wire
Tie
Wire
77