Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Gymstick GT3.0
Summary of Contents for Gymstick GT3.0
- Page 1 GT3.0 TREADMILL USER MANUAL IMPORTANT: Read all instructions carefully before using this product. Retain this owner’s manual for future reference. The specifications of this product may vary from this photo, subject to change without notice.
-
Page 2: Table Of Contents
BEFORE YOU BEGIN Thank you for choosing the Gymstick GT3.0 Treadmill. We take great pride in producing this quality product and hope it will provide many hours of effective exercise to make you feel better, look bet- ter and enjoy life to its fullest. -
Page 3: Safety Instructions
• The maximum weight capacity for this product is 120kgs. WARNING! BEFORE BEGINNING THIS OR ANY EXERCISE PROGRAM, CONSULT YOUR PHYSICIAN FIRST. THIS IS ESPECIALLY IMPORTANT FOR INDIVIDUALS OVER THE AGE OF 35 OR PERSONS WITH PRE-EXISTING HEALTH PROBLEMS. GT3.0 TREADMILL... -
Page 4: Assembly Instruction
ASSEMBLY INSTRUCTION When you open the carton, you will find the below spare parts: DES. Specification Nos. DES. Specification Nos. Treadmill Safety key Console Power wire GT3.0 TREADMILL... - Page 5 ASSEMBLY INSTRUCTION STEP 1 GT3.0 TREADMILL...
- Page 6 ASSEMBLY INSTRUCTION STEP 2 GT3.0 TREADMILL...
- Page 7 ASSEMBLY INSTRUCTION STEP 3 GT3.0 TREADMILL...
- Page 8 ASSEMBLY INSTRUCTION STEP 4 GT3.0 TREADMILL...
- Page 9 ASSEMBLY INSTRUCTION STEP 5 GT3.0 TREADMILL...
- Page 10 ASSEMBLY INSTRUCTION STEP 6 GT3.0 TREADMILL...
-
Page 11: How To Move Treadmill
HOW TO MOVE THE TREADMILL GT3.0 TREADMILL... -
Page 12: Important Electrical Information
2. NEVER operate the treadmill using a generator or UPS power supply. 3. NEVER remove any cover without first disconnecting power. 4. NEVER expose the treadmill to rain or moisture. This treadmill is not designed for use outdoors, near pools or in any other high humidity environment GT3.0 TREADMILL... -
Page 13: Computer Operation Instructions
6.PULSE: Display user’s heart rate, this date is just for reference, can not be regarded as medical use.Hold the hand pulse sensor by both hands,the console will show user’s pulse value after about 5 seconds. 7.MODE: Press Mode button to enter TIME, DISTANCE, CALORIES ,15 programs , 3 users programs and body fat setting. GT3.0 TREADMILL... - Page 14 “STOP” button for 3 seconds, and the system warning sound will disappear. SAFETY LOCK FUNCTION: Under any mode, if you pull away the safety key, the machine will stop. The window will show “---” with reminding sound. The machine cannot work until safety key is inserted back. GT3.0 TREADMILL...
-
Page 15: Preset Training Programs
SPEED button to adjust the speed if needed. When the program enters the next segment, it returns to the set speed. After completing a program, the system will make 6 sounds and display “END” to stop slowly. GT3.0 TREADMILL... - Page 16 Setting time/10=working time of each section TIME PROGRAM SPEED INCLINE SPEED INCLINE SPEED INCLINE SPEED INCLINE SPEED INCLINE SPEED INCLINE SPEED INCLINE SPEED INCLINE SPEED INCLINE SPEED INCLINE SPEED INCLINE SPEED INCLINE SPEED INCLINE SPEED INCLINE SPEED INCLINE GT3.0 TREADMILL...
-
Page 17: User Programs
This console has a built-in USB Port which enables charging many USB Devices. Please note! charging increases the power consumption and the power supplied from the USB port may not be enough to operate the device and charge it at the same time. Use supplied adapter (9V 1.3A). GT3.0 TREADMILL... -
Page 18: Maintenance And Care
Continue this process until belt is at the correct tension. Make sure to adjust both sides equally to ensure correct belt alignment. Refer to figure C. GT3.0 TREADMILL... -
Page 19: Lubricating The Treadmill
The following time table is recommended: Light user less than 3 hours/week every six months Medium user 3-5 hours/week every three months Heavy user more than 5 hours/week every two months GT3.0 TREADMILL... -
Page 20: Troubleshooting
Check that the incoming power Incoming voltage is lower than supply is the correct voltage. E02: Burst clash protection 50% of the required voltage. Check the control board, replace if damaged. Check motor, replace if damaged. GT3.0 TREADMILL... - Page 21 Inspect moving parts of the moving part of the treadmill is E10:Motor Abnormality treadmill to ensure that they are stuck and therefore the motor operating correctly. is unable to rotate properly. Replace the motor if necessary. Lubricate the treadmill. GT3.0 TREADMILL...
-
Page 22: Exploded Drawing 1
EXPLODED DRAWING 1 GT3.0 TREADMILL... - Page 23 EXPLODED DRAWING 2 GT3.0 TREADMILL...
-
Page 24: Parts List
Magnetic core Cylindrical cushion Power wire Ring-shape wire plug AC signle wire Brown 200 EVA cushion AC signle wire Brown 350 EVA cushion AC signle wire Blue 350 Console wire cover Ground wire Console Control board Top signal wire GT3.0 TREADMILL... - Page 25 Safety key sensor bottom USB power wire signal wire Keyboard connectting wire Screw ST2.9*8 Incline motor Power amplifier board Audio input and output board Power amplifier power wire Audio socket wire Speaker 1 Speaker 2 Mp3 wire Screw ST2.9*8 GT3.0 TREADMILL...
-
Page 26: Implied Warranty
• Normal wear and tear of the wear parts The device is intended only for home use. Manufactured for: Gymstick International Oy Ratavartijankatu 11 15170 Lahti, FINLAND Devices marked with this symbol must be disposed of separately from your household waste, as they contain valuab- le materials which can be recycled.
Need help?
Do you have a question about the GT3.0 and is the answer not in the manual?
Questions and answers