Stihl BGA 200 Instruction Manual page 9

6 Adjusting Blower for User
► Take out the screws (1).
► Insert holder (2).
► Insert screws (1) and tighten them.
3
► Open the buckles (3 and 4).
► Guide the belt (6) through the opening (5) from
behind.
3
► Close the buckle (3).
The buckle (3) engages with an audible click.
The belt is located on the back between the
buckle (3) and the deluxe carrying system.
► Move the comfort support system so that it is
centered on the side of the thigh.
► Close the buckle (4).
The buckle (4) engages with an audible click
and the deluxe carry system is secured.
8
► Remove the screw (7).
► Adjust plate (8) to suit user's height.
0458-812-0121-B
4
5
4
7
► Insert the screw (7) and secure it firmly.
6
► Attach the blower to the deluxe carrying sys‐
tem.
The height of the plate (8) is correct when the
user's arm is slightly bent while guiding the
blower by the front gripping point (9).
6.5 Using with Carrying System
6.5.1 Fitting and Adjusting the Connecting
Cable
The connecting cable can be fitted and adjusted
to suit the user's size and the application.
The connecting cable can be fitted through the
following openings:
– the upper left opening (1)
– the upper right opening (2)
– the lower left opening (3)
– the lower right opening (4)
1 2
► If the connecting cable is fitted through the
upper left opening (1) or the upper right open‐
ing (2):
► Open the press studs (5).
► Lay the connecting cable over the shoulder
strap (6).
► Close the press studs (5).
1 2
3
5
6
3
7
English
9
4
4
9