Stihl BGA 200 Instruction Manual page 10

English
► If the connecting cable is fitted through the
lower left opening (3) or the lower right open‐
ing (4): Seal the opening you use (3 or 4) with
the hook and loop fastener (7).
► Arrange the connecting cable so that it is as
short as possible without hindering your work.
6.5.2 Fitting and Adjusting the Carrying Sys‐
tem
► Put the battery on your back.
► Close buckle (2) on the waist belt.
► Close buckle (1) on the chest strap.
3
► Tighten the straps until the waist belt fits
snugly on your hips and the back padding is
against your back.
► Thread the end of the waist belt through the
loop (3).
► Fit the hip pad as described in the instructions
supplied with the hip pad.
2
► Adjust the strap (1) so that the carabiner (2) is
about a hand's width below your right hip.
6.6 Fitting the Hip Pad
The hip pad serves to secure the blower to the
STIHL AR L or AR battery or the carrying system
with built-in "AP belt bag with connecting cable".
10
1
1
► Fit the hip pad as described in the instructions
supplied with the hip pad.
1
2
► Adjust the strap (1) so that the carabiner (2) is
about a hand's width below your right hip.
► Connect the carrying ring (3) to the carabi‐
ner (2).
6.7 Using with Battery Belt
6.7.1 Attaching the "Belt bag AP with con‐
necting cord"
1
2
► Open the Velcro® fastening on the strap (1)
and pull the strap (1) out of the ring (2).
► Feed strap (1) through belt (3).
3
1
► Feed strap (1) back through the ring (2) and
the belt (3).
► Close the Velcro® fastening on the strap (1).
6 Adjusting Blower for User
2
3
1
3
1
4
5
0458-812-0121-B
6