Strymon TIMELINE User Manual page 9

TimeLine
- User Manual
Delay Machines: Dual
Two independent delay lines that can be run in series or parallel. The second delay tracks the first at selectable time ratios.
This is very useful for creating interesting rhythmic delays that feed into each other or act independently in parallel.
PARAMETERS:
Time 2:
Repeats 2:
Mix 2:
High Pass:
Configuration:
Set the CONFIG param to PARALLEL to get independent Right and Left channel delay lines
TIPS & TRICKS:
(the two parallel delays will be summed to mono in mono operation - very useful for rhythmic delays). This also
allows for a 'wet - dry' stereo setup as follows:
CONFIG param to PARALLEL ::: Turn the MIX knob to minimum (dry) ::: Set RPT2 param to TRACK
Set TIME2 param to 1:1 ::: Set MIX2 param to set the level of the delays
Now the knobs on the machine will control Delay2 (Right channel), while Delay1 (Left channel) is dry only (since
MIX knob is minimum). The repeats will only be heard from the Right channel.
DUAL
Adjusts the delay time of Delay 2 relative to Delay 1. Since Delay 2 is a ratio of Delay 1, it adjusts with
changes in delay TIME or Tap Tempo to keep the same ratio, and allows for cool rhythmic effects.
1/8
1/7 2/5
1/6 1/2
1/5 2/3
1/4 3/4
1/3 4/5
Adjusts the repeats level of Delay 2. Set to TRACK to follow Delay 1 Repeats knob. When not set to TRACK,
you can set an independent repeat level for delay 2. In this case changing the Repeats knob will only
affect the repeats level for Delay 1.
TRACK
|||||||||||
Adjusts the mix level of Delay 2. Set to TRACK to follow Delay 1 Mix, set by the Mix knob. When not set
to TRACK, you can set an independent mix level for delay 2. In this case changing the Mix knob will only
affect the mix level for Delay 1.
TRACK
|||||||||||
Reduces the low frequency content of the wet signal after the delay. A useful additional tone sculptor for
delays on low-note riffs or chords where you want to reduce booming in your rig.
OFF
20Hz
40Hz
60Hz
80Hz
100Hz
Select from a series or parallel dual delay setup. In series, Delay 1 feeds Delay 2, just as if you had two
independent stereo delays connected on your pedalboard. In parallel configuration, the input signal goes
to Delay 1 and Delay 2 simultaneously, and the output of the two delays are fed to the Left and Right
channels respectively (or summed to the Left channel in Mono operation).
SERIES
PARA
5/6 3/2
7/8 5/3
1/1 2/1
5/4 5/2
4/3 3/1
120Hz 230Hz
140Hz 260Hz
160Hz 300Hz
180Hz 350Hz
200Hz 400Hz
7/2 8/1
4/1
5/1
6/1
7/1
500Hz
600Hz
700Hz
800Hz
900Hz
®
pg 9