Strymon TIMELINE User Manual page 20

TimeLine
- User Manual
Looper
TAP LED will turn
red to indicate looper
controls are active and
blink green to show
delay time.
TAP
STOP
hold (looper)
hold the TAP
footswitch to enter the
looper
TIPS & TRICKS:
Reverse, Half Speed, Undo (to initial recorded loop) and Redo.
NOTE: The loop can be played in the background if desired. Normally the loop will stop when exiting the looper. To
keep playing the loop when exiting looper set the Looper Exit global to PLAY. The looper can also be controlled via
MIDI at all times.
LOOPER GLOBALS: There are controls to vary the loop level, looper exit behavior and looper pre or post
configuration in the GLOBALS menu. Please consult the globals section of the manual for more information.
LOOPER MIDI CONTROL: Controlling the looper via MIDI is accomplished by sending MIDI note numbers with a
velocity greater than zero OR MIDI CCs. Record, Play, Stop, Reverse, Half Speed, Undo (to initial recorded loop) and
Redo can all be controlled via MIDI. See the MIDI specification for the note numbers and CCs.
A
REC / DUB
push the A footswitch
to start recording
Connect an external MIDI controll to access additional looper features like
The A LED will
turn amber to
indicate looper is
overdubbing
A
REC / DUB
push the A footswitch
again to overdub
OR
B
PLAY
push the B footswitch to
play the loop. Any time the
B footswitch is pressed it
will re-trigger the loop.
TAP
STOP
hold (looper)
push the TAP
footswitch to stop loop.
or
hold the TAP
footswitch to exit
pg 20
®