Strymon TIMELINE User Manual page 16

TimeLine
- User Manual
Delay Machines: Filter
A delay with synchronized sweeping filter affecting the repeats. The filter can be placed pre or post
delay.
PARAMETERS:
LFO
(Low Frequency Oscillator):
Speed:
Depth:
Filter Q:
Location:
High Pass:
FILTER
Selects from a variety of LFO waveforms to control the filter
envelope of the delayed signal. Choose a sine at slow speed for atmospheric
treatments. Choose a random LFO at higher speeds and high Filt-Q for a
futuristic sound.
+Triangle
-Triangle
-Square
+Square
+Sine
Selects the ratio at which the LFO tracks the delay time.
1/32
1/24 1/9
1/18 1/8
1/16 1/7
1/12 1/6
1/10 1/5
Selects the depth or intensity of the filter sweep. Use in conjunction with the Filter knob, which sets the
mid-point of the sweep, to get the precise range you desire.
OFF
|||||||||
Adjusts the Q, or resonance, of the sweeping filter. Lower values produce milder filtering effects
with a broader response and lower resonance. Higher values create sharper resonant peaks which
can lend to dramatic sweeping and special effects
0.5
0.7 1.2
1.0 1.5
This parameter places the LFO-controlled filter either before the delay line
(PRE) or after the delay line (POST). The sonic differences between the two
can be substantial, with POST creating a more prominent effect.
PRE
POST
Reduces the low frequency content of the wet signal after the delay. A useful
additional tone sculptor for delays on low-note riffs or chords where you
want to reduce booming in your rig.
OFF
20Hz
40Hz
60Hz
80Hz
100Hz
-Sine
Ramp
Saw
Random
1/4 1/1
1/3 4/3
1/2 3/2
2/3 5/2
3/4 3/1
2.0 3.0
2.5 4.0
120Hz 230Hz
140Hz 260Hz
160Hz 300Hz
180Hz 350Hz
200Hz 400Hz
TIPS & TRICKS:
'+' or '-' in front of the
SINE, TRI and SQR
lfo shapes designates
the polarity of the
LFO when it sync to
your playing. The '+'
LFO shapes will have
the highest frequency
occur synchronous to
the input, while the '-'
Down
LFOs will have their
lowest frequencies
Up
synchronous to the
input.
7/2 8/1
4/1 9/1
5/1 10/1
6/1 12/1
7/1 16/1
5.0 10.0
7.0
TIPS & TRICKS:
FILT-Q parameter
sets the resonance or
sharpness of the filter.
At higher settings, the
increase in amplitude
at the filter's resonant
frequency can result in
an increase in apparent
wet signal volume.
Use the MIX knob to
adjust the wet level
500Hz
accordingly.
600Hz
700Hz
800Hz
900Hz
®
The
18/1
24/1
32/1
The
pg 16