Table of Contents
Advertisement
Service
Replacement Procedure
Removing the Plastic Regulator Housing Covers
Tools Required:
1/8 inch-wide flatblade screwdriver
WARNING
In the steps below, hold the regulator housing and screwdriver so that you won't
injure yourself if the screwdriver slips.
Refer to
Figure
7-8.
1. Hold the regulator assembly by one end and insert the head of a 1/8 inch-wide flatblade screwdriver
into the seam at the other end. The seam separates the two halves of the housing cover. Twist the
screwdriver 90°.
2. Perform step 1 in several places along the four pry points shown in
Reassembling the Covers
3. Replace the metal housing reinforcement and plastic covers as show in
reinforcement is very important; it ensures that the covers will not pop off if the unit is dropped.
Figure 7-8
Cover Removal
7-10
Figure
7-8.
Figure 6-1 on page 6-5.
Chapter 7
The
Advertisement
Table of Contents
Troubleshooting
