SubC Imaging 1Cam Mk5 SD Manual page 22

Live sd color zoom hd and stills recording
Table of Contents

Advertisement

EXAMPLE OF DEPLOYMENT
A drop camera system scenario
This section introduces the basic camera configuration steps needed to
perform a typical recording deployment of a 1Cam MK5 as
Camera System
and
continuous HD recording needed with
Connect camera to the computer:
1.
the
Comms
tab, select the port where you camera is plugged in, and
click
Connect
Active HD:
Go to the
Options
2.
button. Make sure infrared filter is off
Set Light:
Click on
LED controls
3.
wish to keep the LED on at all times when there is power to the
camera. Set lamp power to desired value
Set Intervals:
Go to the
4.
3600s, and
Record
to 9999s. Press Start. Now
run through its commands until it starts counting down
Disconnect:
Now that all intervals are ready, go to
5.
Disconnect
Deployment:
Take the camera out on deck and connect it to the
6.
frame, light and battery cables and deploy your system in water
7.
After retrieval repeat
Step 1
Reset Intervals:
Go to the
8.
the interval configuration
Download footage:
To start downloading your footage to the
9.
Options
tab, click on USB. A window will appear accessing the folder
with all your videos/pictures
part of a Drop
illumination:
Open camera software, go to
tab, enable HD by clicking the
tab, click on
LED on
button if you
Intervals
tab, set
Wait To Start (WTS)
wait for the camera to
Comms
Intervals
tab and click on
Reset
Important notes on this example:
From
Step
into interval mode and will record during 9999 seconds
In
Step
3, if light is ONLY needed while recording, click on
under the
power
There are
HD/SD
Internal memory has 96GB. To switch between both options go to
the
Menu
source from the menu
1
to
2
and click
to stop
3
2
4, the camera will wait for 3600 seconds before going
Triggers
category. This option is better to save battery
two options for
memory. Internal and memory card.
option in the
Camera controls
4
2
Record
tab and pick your storage

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 1Cam Mk5 SD and is the answer not in the manual?

Table of Contents