Electrical Safety - Raider RD-ESH02 User Manual

rotate for a few seconds.
4.4. Ensure balance and good stability. Never lean forward and never stand higher than the device
when placing material.
4.5. Never dispose of solid materials such as metals, stones, glass, or other foreign objects.
4.6. Do not use the machine in rain or bad weather. Work only in daylight or in good artificial light.
4.7. Do not use the machine when you are tired or anxious if you have used alcohol or drugs. Take
regular breaks and work wisely.
4.8. Turn off the device and unplug it in the following cases:
• when you stop using the machine, during transportation or when leaving the machine unattended;
• when performing repair work on the device, such as unbundling, cleaning, maintenance or
inspection;
• when replacing spare parts;
• if the electrical or extension cable is damaged;
• if you are going to move or lift the machine;
• if vibrations or noise occur (always check for damage before restarting the appliance);
• if there is a foreign object caught in the machine.
4.9. Do not allow material to accumulate in the discharge area, it may prevent proper discharge and
cause material to return to the inlet.
4.10. Do not transport, lift or turn the machine over with the engine running
4.11. Do not put your hands, other parts of your body, or clothing in the filler hole near the exhaust
duct or other moving parts.
4.12. In the event of a blockage of the intake or discharge port, switch off the engine and disconnect
the plug before removing material residues from the duct or vent.
4.13. Make sure there are no debris and other objects around the engine to protect it from damage
or possible fire. Keep in mind that when turning on the power tools, all cutting tools also start working.

5. ELECTRICAL SAFETY

Attention! Do not touch the damaged cable and pull the plug when the cable is damaged during
operation. Damaged cables increase the risk of electric shock.
If the power supply is damaged, it must be replaced immediately with a defective cable to avoid
dangerous situations.
5.1. Do not expose this machine to rain, even if you do not use it, or leave it in a humid environment
and outdoors where it may be wet. Maintain good lighting in the workplace.
5.2. Do not use the machine in a location where there is a risk of fire or explosion.
5.3. Protect yourself from electric shock.
5.4. Protect the power cord from heat, grease, corrosive liquids and sharp edges.
5.5. Check the power cord regularly and check for damage or aging.
5.6. If the power cord is damaged, you should consult an authorized service center to prevent the
hazard.
5.7. Do not plug the damaged power cord into the power supply or touch the damaged power cord
before unplugging it.
5.8. Only work in a place that you can be safe.
5.9. Avoid accidental starting. Always remove the plug when transporting. When connecting the plugs
to the socket, make sure the switch is off.
5.10. When working outdoors, use only extension cords that are approved and appropriately marked
for this application and with wires with a suitable cross-section.
5.11. Check for damaged parts. Prior to the next use of the device, it is necessary to check the
17