Electrical Requirements; Installation - Raider RD-ESC01 User Manual

example the dangers caused by an unhealthy body position or excessive recharging and unnatural
human anatomy, relate to the design of the handle, the equilibrium of the machine.
3.10. The dangers caused by an unexpected start-up, an unexpected exceeding of the engine
speed caused by a defect / failure of the control system relate to defects in the handle and the
positioning of the drivers.
3.11. The hazards caused by the inability to stop the machine in the best conditions relate to the
strength of the handle and the installation of the engine shutdown device.
3.12. The hazards caused by a defect in the machine control system relate to the strength of the
handle, the positioning of the guides and the marking.
3.13. Dangers caused by the launching of objects or splashes of liquids.
ATTENTION! The product produces an electromagnetic field of very low intensity. This field
may interfere with some pacemakers. To reduce the risk of serious or fatal injury, people with
pacemakers should consult their doctor and manufacturer.

4. ELECTRICAL REQUIREMENTS

4.1. Never use at a rated voltage other than 230V / 50Hz. The circuit must be properly and
properly protected against current.
RECOMMENDATIONS FOR CLASS II MACHINE PROTECTION
4.2. Machines must be powered by a current protector (RCD) having a cut-off current of not
more than 30 mA.
5. UNPACKING
5.1. Carefully remove the product from the box.
5.2. Do not dispose of packaging materials until they have been carefully inspected if they do
not remain part of the product.
5.3. Parts of the packaging (plastic bags, paper clips, etc.) cannot be kept out of reach of
children, could be a source of danger. Do not allow children to play with plastic bags, foil, or small
parts. There is a risk of ingestion or suffocation!
5.4. Make sure plastic bags and containers are left in the environment freely because they are
dirty.
5.5. Disposal must be carried out in accordance with the regulations in force in the country in
which the product is installed.
5.6. If in doubt, do not use the product, but check with an authorized service center.

6. INSTALLATION

Follow the step-by-step instructions and use the pictures provided as a visual guide for easy
assembly of the machine.
6.1. Handle
6.1.1. Remove the locking levers, washers and clamps.
6.1.2. Insert the lower handle into the brackets.
6.1.3. Attach the lower handle to the appliance housing with screws and washers.
6.1.4. Connect the upper and lower handle to the bolts and washers.
6.1.5. Attach the cable using the cable clamp.
6.2. Assembly of a grass basket
6.2.1. Insert the two parts of the metal frame into each other.
6.2.2. Place the metal frame inside the grass catcher.
6.2.3. Pull the rubber clips onto the metal frame.
6.3. Mounting and dismantling the grass basket
6.3.1. Placing: Lift the back cover and hook the grass collector from the back to the machine.
17