Set Point Screen - From Main Screen; Units Screen - From Main Screen - Emerson Dixell iPro Master IPM500D Installing And Operating Instructions

5.1.2 SET POINT SCREEN – FROM MAIN SCREEN
Main information:
 System Status: here is shown the state of the system (Cooling, Heating or Off).
 Cooling Set Point: here is shown the actual cooling set point if the system is configured for Cooling
mode or for Cool & Heat mode. The setpoint can be changed using the screen keys.
 Heating Set Point: here is shown the actual cooling set point if the system is configured for Heating
mode or for Cool & Heat mode. The setpoint can be changed using the screen keys.
Main actions:
Esc key: this key is used to go back on the previous page.

 Up & Down keys: these keys are used to select the setpoint that need to be changed. They are also
used the change the value after the enter key is pressed to activate the change mode.
 Enter: this key is used to enter the change mode and also to confirm the new value for the selected
set point.
Alarm Page: this button open the alarms and notify page. When a notify is active a bell will be shown

on the top roght of the screen
5.1.3 UNITS SCREEN – FROM MAIN SCREEN
Main information:
Units Status: here is shown the the state of all the units connected to the system. For every unit are

shown the following information:
Index: rapresent the unit index from 1 to 10
o
Unit state: rapresent the general state of the unit (On, Off, Offline)
o
Local resources: here are shown the active and available resources for the single unit. When
o
a unit is off, in alarm or in defrost the resources will be always considered 0 / 0
Defrost state: this icon show which unit is perform a defrost
o
Main actions:
 Esc key: this key is used to go back on the previous page.
User manual IPM500 EN rel1.0.doc iPro Series 11/48