Table of Contents
Advertisement
6
SET POINT
The set point indicates the working temperature set on the unit. The control probe for the chiller and
heat pump modes is the input temperature in the main heat exchanger (i.e. the return temperature
from the system), indicated in red on the first line of the display.
The control probe for the production of domestic hot water (accessory) must be positioned by the
installer in the storage tank. Its value can be displayed by selecting the SAn1 label using the arrow
keys (see previous chapter).
6.1 Set point visualisation
Press and release the button ; the leds of the circuits are off and the set value is displayed.
When the unit is in standby, pressing once
the lower display will show SetC (set chiller).
Pressing the key again SetH (heat pump set) will
be shown. If the domestic hot water is managed,
the relative set point will also be displayed via the
SetS label. The value of the set point is displayed in
the upper row.
IC200CX EVO
user manual
15
Advertisement
Table of Contents
