Icons; Set-Point Menu; Setpoints Visualization - Emerson Dixell XC15CX Installing And Operating Instructions

Manual load restart:
if par. r1F=rSt, press this button to restart the loads and previously
stopped due to safety alarm
ON-OFF:
if par. r2F=onF, keep this button pressed for 3 sec to switch ON and
OFF the instrument
SERVICE / CLOCK: to enter CLOCK and SERVICE menu
STORED ALARMS:
it gives access to the stored alarms
KEY COMBINATION
UP + DOWN
SET + DOWN
SET + UP

7.3 ICONS

LED STATUS
ON
ON
ON
ON
ON
BLINKING
ON
BLINKING
ON
BLINKING
ON
ON
BLINKING
ON
ON
BLINKING
ON
ON

8. SET-POINT MENU

8.1 SETPOINTS VISUALIZATION

1. Press and release the SET button
2. SUCTION: the display will show the label St1 [Compressor setpoint]
3. Press the SET button again to show the value of St1
1592001530 XC15-35CX EN r1.2 11.04.2017
To lock and unlock the keyboard
To enter the programming parameter menu
To exit from INFO and ALARM menu and from programming parameter
menu
MEANING
Unit of measurement for temperature is Celsius degrees
Unit of measurement for temperature is Fahrenheit degrees
Unit of measurement for pressure is Bar
Unit of measurement for pressure is PSI
Relay output oA1 enabled
Delay in relay output oA1 activation
Relay output oA2 enabled
Delay in relay output oA2 activation
Relay output oA3 enabled
Delay in relay output oA3 activation
Analogue output active
(SER) Service menu
(SER) Outputs in service mode
(ALR) Alarm active
(MEM) At least an alarm present into memory
(MEM) A new alarm is occured and need to be checked
Energy Saving mode active
Real Time Clock Menu
XC15-35CX 14/40