Table of Contents
Advertisement
2. With the sides and back of the shelf facing up, carefully lift the shelf into the
3. Align the holes in the shelf flange exactly with the holes in the front rack rails.
4. Holding the shelf 1 level, insert a screw through the top hole 3 in each
Figure 2-1. Front view of shelf attached to rack rails
5. Check that the shelf is at the same level on the four mounting rails.
6. Insert a screw through the bottom hole 4 in each front flange of the shelf.
7. Tighten all mounting screws using a 7 mm nut driver or a 7 mm socket
8. Route cables down one of the rear rack rails by threading each tie wrap
The shelf installation is complete. You can now install your equipment on the shelf.
Removing the shelf from the rack
To remove the shelf from the rack, reverse the steps in the installation procedure.
Inspect the Power Cord and Outlet
1. Inspect the power cord plug to ensure that it matches the power receptacle. If it
2. Ensure that all associated electrical outlets are properly grounded and that the
rack between the front and back rack rails with the shelf flanges behind the
front rack rails.
front flange of the shelf. Loosely thread the screws into the front mounting
rails.
3
4
Loosely thread the screws into the front mounting rails.
wrench.
through a hole in the rail and around the cables. One tie wrap should be
located near the rear of the drive; the other should be located farther down the
rack rail. Tighten cable ties securely around the cables so the cables cannot be
pulled out. Cut off tie wrap excess.
Attention: It is important to install cable ties on the cables! This helps secure
the equipment on the shelf from being accidentally pushed off or from slipping
off the front of the shelf.
does not match, see "Power Cords" on page C-1 to determine the appropriate
power cord.
circuit breaker is turned on.
1
3
2
4
2-3
Chapter 2. Installation
Advertisement
Table of Contents
