Step 2. Using the Inventory Checklist
Ensure that you have received the following items:
__ 1. Power cord (for the appropriate cord for your country or region, see
__ 2. IBM LTO Ultrium Data Cartridge
__ 3. IBM TotalStorage LTO Ultrium Cleaning Cartridge
__ 4. Single-connector SCSI wrap tool
__ 5. Device driver kit that includes:
__ 6. A host-to-device SCSI bus (signal) cable and a terminator
__ 7. Optional rackmount kit (if ordered)
__ 8. The IBM TotalStorage Ultrium Tape Drive 3580 Models L23 and H23 Quick
__ 9. The IBM TotalStorage Ultrium Tape Drive 3580 Models L23 and H23 Setup and
__ 10. The IBM Externally Attached Devices Safety Information manual
Step 3. Installing the Rackmount Kit
If you ordered the optional rackmount kit, refer to Appendix D, "Installing a Tape
Drive into a Rack", on page 97 for installation instructions. If you did not order the
optional rackmount kit, proceed to "Step 4. Inspecting the Power Cord and
Outlet".
Step 4. Inspecting the Power Cord and Outlet
__ 1. Inspect the power cord plug to ensure that it matches the power receptacle.
__ 2. Ensure that the electrical outlets that you use are properly grounded and
6
IBM 3580 Ultrium Tape Drive Setup and Operator Guide
Appendix F, "Power Cords", on page 105)
v CD that contains the device drivers, the IBM Ultrium Device Drivers
Installation and User's Guide, and the IBM Ultrium Device Drivers
Programming Reference
Reference, GX35–5068
Operator Guide, GA32–0460 (this guide)
If it does not match, see Appendix F, "Power Cords", on page 105 to
determine the appropriate power cord.
that the circuit breaker is turned on.