No Apparent Failure Or Damage To Tape; Rewinding Tape Into Cartridge - IBM System Storage TS2230 Setup, Operator, And Service Manual

Figure E-10. Rewinding tape into cartridge
1
Loader motor worm gear
2
Outer guide rail
WARNING: DO NOT
TOUCH
3. Turn the supply reel ( 4 in Figure E-10) clockwise.
4. Continue spooling into the cartridge until the tape is taut and remains within
the flanges of the tape guiding rollers. turn the supply reel ( 4 in Figure E-10)
10 turns. Ensure that you do not stretch the tape.
5. Reassemble the chassis by following the steps in "Removing a Drive from an
Enclosure" on page E-1.
6. Allow the drive to perform mid-tape recovery. This takes several minutes.
When this activity completes, push the Unload button to eject the cartridge.
7. Test the drive (see "Function Code 1: Run Drive Diagnostics" on page 3-9) to
determine if it should be replaced.

No Apparent Failure or Damage to Tape

1. Set the drive on its left side with the head and tape path facing up.
2
1
4
3
Takeup reel motor
4
Supply reel motor
Appendix E. Information for Trained Service Personnel
3
E-11