To reduce the risk associated with choking, do not allow children under 3 years of age to have access to small parts during the installation of this product. For Monogram local service in your area, call 1.800.444.1845. For Monogram Parts and Accessories, call 1.800.626.2002.
Page 3
Consignes de Sécurité Ce symbole représente une alerte de sécurité. Ce symbole vous avise de dangers possibles pouvant causer la mort, des blessures ou autres. Tous les messages de sécurité seront précédés du symbole d’alerte de sécurité ainsi que des mots « DANGER », «...
Design Guide For models ZIFS240 and ZIBS240 with Stainless Steel Doors and Handles THE INSTALLATION SPACE THE INSTALLATION SPACE (cont.) Flush Installation 1/4” NOTE: Filler panel or cleat to be set Water line location for CABINET CABINET back even with front of case. ZIBS240 model only Front edge of product case Front face...
NOTE: Right-hand models illustrated. Allow the same clearances on the opposite side for left-hand fresh food models ZIFI240 and ZIFS240 only. Models ZIBI240 and ZIBS240 are not available with left-hand door swing. • Test the door swing. Carefully open and close the door.
Design Guide For models ZIFI240 and ZIBI240 with Custom Door Panels and Handles THE INSTALLATION SPACE SIDE-BY-SIDE INSTALLATIONS For a complete refreshment center, install a Fresh- Food Refrigerator beside a Double-Drawer Refrigerator, Beverage Center or Wine Chiller/Wine Reserve. Or, install a Refrigerator with Icemaker beside a Wine Chiller/Wine Reserve.
Installation Instructions STEP 2 REVERSING THE DOOR STEP 1 REMOVE PACKAGING AND INSTALLATION PARTS (ZIFI240 model only) • Remove corner blocks and foam drawer stops. • Remove the top hinge pin (do NOT • Remove all packing material, tape and protective discard).
Page 9
STEP 2 REVERSING THE DOOR STEP 2 REVERSING THE DOOR (Cont.) (ZIFS240 model only) (ZIFI240 model only) • Remove top hinge and discard. Hold the door in place. • Install the new left bottom hinge pin and new door stop that are enclosed in the hardware bag.
Page 10
Installation Instructions STEP 2 REVERSING THE DOOR STEP 2 REVERSING THE DOOR (Cont.) (Cont.) (ZIFS240 model only) (ZIFS240 model only) • Re-insert the black screw post in the new bottom of the • Remove top plug/bushing from the door using a flat door.
STEP 3 INSTALL CUSTOM 3/4” STEP 3 INSTALL CUSTOM 3/4” DOOR PANEL AND HANDLE DOOR PANEL AND HANDLE (ZIFI240 and ZIBI240 models only) (ZIFI240 and ZIBI240 models only) 3/4” Overlay Panel Dimensions Custom Panel Hinge Routing Dimensions Model ZIFI240 and ZIBI240 require a field-installed overlay door panel.
PANEL AND HANDLE (CONT.) • Use an adjustable wrench to turn the leveling legs and (ZIFI240 and ZIBI240 models only) raise or lower the product. For built-in installation, adjust • Slide overlay panel into the door trim. the leveling legs slightly below the bottom of the countertop.
Installation Instructions STEP 6 CONNECT POWER STEP 8 SET TEMPERATURE CONTROLS • Connect power cord plug to a properly grounded receptacle. • The temperature controls are preset. Refer to the • Check to make sure power is on by opening the door Owner’s Manual for more information.
Page 16
NOTE: While performing installations described in this book, safety glasses or goggles should be worn. For Monogram local service in your area, call ® 1.800.444.1845. NOTE: Product improvement is a continuing endeavor at General Electric. Therefore, materials, appearance and specifications are subject to change without notice.
Need help?
Do you have a question about the ZIFI240 and is the answer not in the manual?
Questions and answers