Advertisement
If you chose Remote Control Panel only, you would not get any of
the Console only displays here.
__ 11. Click on Next to allow the system to detect the console communications
port. System should find the port and select it automatically. If not,
manually select.
__ 12. Click on Next, to allow the system to detect the Remote Control Panel
communications port. System should find the port and select it
automatically. If not, manually select.
__ 13. Click on Next.
__ 14. A Success.... message appears. Click on Finish.
__ 15. When the installation completes, Operations Console will connect to the
system automatically.
__ 16. Did you configure Operations Console with a Remote Control Panel?
Yes
No
↓
Go to step 18.
__ 17. Did the Remote Control Panel appear when the setup was finished?
Yes
No
↓
Recheck the cables and Operations Console setup. Then return to
step 16.
If your AS/400 system unit will be using a twinaxial console, use the
Remote Control Panel to power on the AS/400. Sign on the DST display.In
the User field, type QSECOFR. In the Password field, type QSECOFR. The
installation is complete.
If you powered the system up in step 3g on page 12, continue with step 18.
__ 18. Did the display AS/400 DST Sign On appear? (The display should appear
within three minutes.)
Yes
No
↓
Recheck the cables and Operations Console setup. Then return to
step 16.
Sign on using the system default values:
v In the DST User ID field, type QSECOFR.
v In the DST Password field, type QSECOFR.
Click on OK.
__ 19. Did the remote console start?
No
Yes
↓
You should see the IPL or Install the system menu. Select Use
Dedicated Service Tools (DST). Then go to step 20 on page 14.
Use the Remote Control Panel on the PC. If you don't have a Remote
Control Panel on the PC, go to the Control Panel at the front of your
AS/400 system unit.
Note: You are here because you are configuring Operations Console with a
Remote Console, however, it failed to start.
13
Installation Instruction
Advertisement
