Advertisement
__ 4. Open the Operations Console icon by doing the following:
__ 5. Select Local Controlling System (LCS) to AS/400 System.
__ 6. Click on Next.
__ 7. Type the system name of the AS/400 you want to connect to.
__ 8. To accept the default value, Direct Cable Connection, click on Next.
__ 9. Indicate which Operations Console actions you want to use with your
__ 10. Click on Next. If you are only using the Remote Control Panel, go to step
12
AS/400e 170 or 250 0367 Operations Console and 0381 Remote Control Panel Cable V4R5
__ g. Press the Power push button that is located on the AS/400 control
panel.
Note: The system takes approximately 5 to 10 minutes to power on
and complete an IPL. You should see data changing in the
Function/Data display.
__ h. Is reference code x6004501 (where the x is, there is a letter or
number) shown in the Function/Data display?
No
Yes
↓
Go to step 4.
__ i. Is the Attention light lit?
Yes
No
↓
If the system shows no activity for more than 10 minutes, go
to the "Handling and Reporting System Problems" section of
the Basic System Operation, Administration, and Problem
Handling, SC41-5206-04, which was shipped with your
system. Then return here and continue.
__ j. Is a System Reference Code (SRC) x6xx500x (where the x is any letter
or number), shown in the Function/Data display?
Yes
No
↓
Go to the "Handling and Reporting System Problems"
section of the Basic System Operation, Administration, and
Problem Handling, SC41-5206-04, which was shipped with
your system. Then return here and continue.
PC Setup
__ a. Start
__ b. Programs
__ c. IBM AS/400 Client Access
__ d. AS/400 Operations Console
Note: The system name is only a reference name and does not need to be
the actual system name. For example, you could name the system
ATLANTA, when the actual name is 10-12345.
Then, click on Next.
AS/400 system. If you installed part number 97H7557 (Operations Console
cable) and part number 97H7591 (Remote Control Panel cable), you need
to select both (Remote Control Panel and Console).
12 on page 13. Otherwise, go to the following Note.
Note: If you chose Console only on the Actions display, you would not get
any of the Remote Control Panel displays here.
Advertisement
