Polaris PVCR 0926W Operation Manual page 21

Attention: Operation of the device without a dust container or without a container for wet cleaning is
strictly prohibited!
2. Place the vacuum cleaner on the floor with the Auto on/off button up.
3. Turn on the device with the I/O switch on the device housing (located next to the adapter
connection slot) by moving it to the I position. (Fig. 4)
4. To activate the device press the Auto button on the device housing once without holding or the
button on the remote control device.
A single beep will sound, the device will enter the standby mode. At the same time, the indicator of the Auto
button of the device housing will flicker green.
5. To start cleaning from the standby mode, press the Auto button on the device housing or the button
the button again
6. A short program lasting 30 minutes is provided for cleaning a small room. To start it from the
standby mode, double-click the Auto button on the device housing or
remote control device.
7. The Maximum cleaning mode will allow the vacuum cleaner to work with increased suction
power.
To enable the mode, use the button on the remote control device.
8. Using the button on the
on the timer (see Section 8). In this case, the current time must also be set (see Section 9).
When the timer is set, the vacuum cleaner will automatically turn on and start cleaning every day at the set
time. The I/O switch on the device should be turned on, the charging base should installed and connected. 9.
In order to transfer the device from standby mode to sleep mode, press the Auto button on the device housing
and hold for more than 3 seconds. In this case, the Auto button indicator on the device
housing will go out. In addition, the device will automatically enter the sleep mode from the
standby mode if you do not press the buttons for 45 seconds. You can remove the device from the
sleep
mode by pressing the Auto button (Section 3). Using the button
you can enter the mode for setting the time the device starts to work. The installation should
be carried out by the buttons 4-7 of the remote control device. Click
setting. To delete the setting, set the time to 00:00.
10. By pressing the
be carried out using the buttons 4-7 of the remote control device. Click
setting.
11. The functions of the buttons 4-7 of the remote control device (up, down, left, right arrows)
depending on the selected mode:
Functions A are available when setting the operating time of the device or the current time (see
Sections 6, 7).
on the remote control device, the vacuum cleaner will start cleaning the room. Pressing
allows you to stop the device.
button you can enter the current time setting mode, the installation should
remote control device you can set the start time of the cleaning
21
the button on the
on the remote control device
again to save the
again to save the