NetApp AFF A700s Manual page 26

If the console
displays...
Waiting for giveback...
4. Move the console cable to the partner controller and give back the target controller storage using the
storage failover giveback -fromnode local -only-cfo-aggregates true local
command.
◦ If the command fails because of a failed disk, physically disengage the failed disk, but leave the disk in
the slot until a replacement is received.
◦ If the command fails because of an open CIFS session, check with the customer on how to close out
CIFS sessions.
Terminating CIFS can cause loss of data.
◦ If the command fails because the partner is "not ready", wait 5 minutes for the NVMEMs to
synchronize.
◦ If the command fails because of an NDMP, SnapMirror, or SnapVault process, disable the process. See
the appropriate Documentation Center for more information.
5. Wait 3 minutes and check the failover status with the
6. At the clustershell prompt, enter the
interfaces that are not on their home controller and port.
If any interfaces are listed as false, revert those interfaces back to their home port using the
command.
revert
7. Move the console cable to the target controller and run the
versions.
8. Restore automatic giveback if you disabled it by using the
-auto-giveback true
9. Use the
storage encryption disk show
10. Use the
security key-manager key query
keys that are stored on the key management servers.
◦ If the
Restored
process.
◦ If the
Key Manager type
use the
security key-manager external restore
authentication keys.
If the command fails, contact Customer Support.
◦ If the
Key Manager type
use the
security key-manager onboard sync
24
Then...
a. Log into the partner controller.
b. Confirm the target controller is ready for giveback with the
failover show
net int show -is-home false
command.
column = yes/true, you are done and can proceed to complete the replacement
=
external
= and the
onboard
command.
storage failover show
version -v
storage failover modify -node local
at the clustershell prompt, to review the output.
command to display the key IDs of the authentication
and the column = anything other than yes/true,
Restored
command to restore the key IDs of the
column = anything other than yes/true,
Restored
command to re-sync the Key Manager type.
storage
command.
command to list the logical
net int
command to check the ONTAP