Angelo Decor AD93707 Quick Manual

Veneto Fountain
We hope you will find these instructions helpful in setting up your product. If you have any issues with this item,
DO NOT return the unit to place of purchase. Please visit our web site www.angelodecor.com for
assistance and warranty information.
Carefully unpack and
arrange all parts.
Install the cord pipe cover
over the cord pipe as
shown.
Connect the tubing to the pump then place the pump
inside the riser. Install the pump access door.
Fill with clean water and plug into a grounded GFCI outlet.
The pump must be fully submersed at all times to avoid pump burnout.
This product must be dried and stored during freezing temperatures.
Carefully rest the large
bowl on its side. Pass the
cord from the pump down
the cord pipe.
Set the riser in to place,
align the grooves then
lower and lock it to the
bowl.
Pass the cord down the
pedestal and align it with
the groove at the base.
Align, lower and lock the
small bowl to the riser.
The included shims can
be used to level the
fountain if needed.
If splash is a concern, the
optional splash reduction
line (shown left) can be
draped through each spill-
point to reduce splash as
needed.
AD93707
Carefully align, lower and
lock the bowl to the
pedestal.
Connect the tubing to the
top then pass it down the
centre of the small bowl.
Lower the top in place.
Printed in China