Angelo Decor Soho AD93411 Quick Start Manual

Soho Fountain
We hope you will find these instructions helpful in setting up your product. If you have any issues with this item,
DO NOT return the unit to place of purchase. Please visit our web site www.angelodecor.com for
assistance and warranty information.
Carefully unpack and arrange all
parts.
Insert the pump into the included
PumpJacket™ pump filter.
Align the cords and install the pump
access door as shown.
Fill with clean water and plug into a grounded GFCI outlet.
The pump must be fully submersed at all times to avoid pump burnout.
This product must be dried and stored during freezing temperatures.
Retrieve the light connection from
inside the fountain.
The light connection must
sit outside the fountain.
Locate the tubing from inside the
fountain and attach it to the output of
the pump. To fine-tune water flow,
the controls can be adjusted on the
diverter as needed.
Attach the cord from the lights to the
transformer.
The pump is preset to the optimal
setting. Adjust water flow as
needed using the dial.
IMPORTANT: to prevent water loss,
create a drip-loop with the light cords
by dipping them into the reservoir
before they exit out the back of the
fountain.
AD93411
Printed in China