Deleted Evaluation Board Setup Procedure And Figure 3 To Figure 6; Renumbered Sequentially; Changes To Evaluation Board Software Section; Evaluation Board Software; Added Evaluation Board Setup Procedure Section Software Installation Section, And Figure 3 To Figure 5 - Analog Devices UG-160 User Manual

Evaluation Board User Guide

EVALUATION BOARD SOFTWARE

The control software for the
the CD included in the evaluation board kit. To install the
software, see the UG-476 user guide, PLL Software Installation
Guide.
To run the software, click the Int-N v7 file on the desktop or
select the file from the Start menu.
On the Select Device and Connection tab, choose the device
and connection method, and then click Connect.
EV-ADF4108EB1Z is provided on
Figure 3. Int-N Software, Main Window—Select Device and Connection
Confirm that Analog Devices RFG.L Eval Board connected is
displayed at the bottom left of the window (see Figure 3). If this
message is not displayed, the software cannot connect to the
evaluation board.
Note that when the board is connected, there is about a 5 sec to
10 sec delay before the status label changes.
From the File menu, the current settings can be saved as and
loaded from a text file.
Rev. B | Page 5 of 16
UG-160