Advertisement
Removing the Backrest Adjusting Lever
1.
Raise the backrest to its highest position.
2.
Using the 5 mm hex wrench and the 10 mm open end wrench,
remove and discard the backrest adjusting lever, spring, screw,
washers and lock nut (Figure 1).
Removing the Backrest Adjusting
Lever
Compress the lever against the backrest tube
to relieve tension. This helps with removing the
screw.
Installing the New Backrest Lever
1.
Insert the 90 degree leg of the spring into the backrest adjusting
lever (Figure 2). The long end of the spring is held by the slot.
2.
Hold the spring in place. Compress the long end of the spring
against the backrest tube and align the screw holes.
3.
Place the lever assembly into the mount (Figure 3). Hold in place
as you complete step 4.
Installing the Backrest Adjusting
Lever
Start high in the backrest tube bracket, then
slide down.
Use an assistant as necessary.
2
F2 Backrest Adjusting Lever Kit
Washer
Lock Nut
Slot
Backrest Tube
© Ferno-Washington, Inc. / 234-3648-00 / December 2016
Screw
Washer
Backrest
Adjusting Lever
Spring
1
Backrest
Adjusting Lever
Spring
2
Handle
Spring
3
Advertisement
