2021/10/20 上午10:47
crew
1. Place the mount over the two anchors.
2. Use the supplied screws to secure the mount in place.
ttach the Wireless Video Doorbell to the Mount
1. Align the prongs on the back of the Wireless Video Doorbell (VDB780B) with the 4 rectangular slots
2. Push the VDB780B into the slots and slide down, until the device clicks into place.
3. Slide the latch on the bottom of the mount to secure the VDB780B in place.
onfirm Battery Charge
1. If the battery was not fully charged as part of the Power on the Wireless Video Doorbell sectio
instructions in the Charging the Battery section.
Charging The Battery
We use cookies on our website to give you the most relevant experience by remembering your
preferences and repeat visits. By clicking "Accept", you consent to the use of ALL the cookies.
fully depleted battery will take approximately 7 hours to charge.
However you may visit Cookie Settings to provide a controlled consent.
1. Unlatch the bottom of the mount.
https://doorbell.poweredbyalarm.com/vdb780b-install/
VDB780B install – Doorbell Camera
Cookie settings
ACCEPT
7/11
Need help?
Do you have a question about the ADC-VDB780B and is the answer not in the manual?