Jumping Parameters; Set Count Down; Set Race Time Ph1; Set Race Time Ph2 - TAG Heuer CHRONOPRINTER 545 User Manual

JUMPING SNG PHASE (Single Phase)
Jumping Mode with two phase separate – Count Down, Start Phase 1, Stop Phase 2,
Start Phase 2, Stop Phase 2)
Refer to the chapter 9 for a full description of those 3 Jumping Modes.
5.7.

Jumping Parameters

5.7.1.

Set Count Down

Set the count down before the start signal (30 or 45 sec).If countdown is not required you set to 0. If
setting to 0 each competitor has to be validated by pressing input 3 prior manually.
5.7.2.

Set Race Time Ph1

Set the Time limit for Phase 1 (sec)
If the value is set at "0", no time penalties will be added.
5.7.3.

Set Race Time Ph2

Set the Time limit for Phase 2 (sec)
If the value is set at "0", no time penalties will be added.
5.7.4.

Set Time P/Ph1

Set Penalty in Ph1 wh/time limit is exceeded (0.25 pts / sec)
5.7.5.

Set Time P/Ph2

Set Penalty in Ph2 wh/time limit is exceeded, it is possible to set the points penalties / time (example:
"0.25 pts / 1 sec" or "1.00 pts / 4 sec")
5.7.6.

Set Pause Penalty

Set a default Time Penalty if pause is requested (sec)
TAG Heuer Timing Page 10 / 49