Preventive Maintenance Test - ZOLL AED PLUS Service Manual

C 1 M
HAPTER AINTENANCE

2.0 Preventive Maintenance Test

Use this test to verify that the AED Plus unit is working properly and ready for use.
For an alternative test using the AED Plus Simulator, refer to the AED Plus Administrator's
Guide.
Note:
Tools Needed
Fluke Impulse 4000 Defibrillator/Pacer Performance Analyzer or equivalent
•
Universal adapter cable
•
Test Setup
Turn off the AED Plus unit, remove the cover, and unplug the preconnected electrodes.
•
Keep the electrodes so they can be reconnected later.
Connect the universal adapter cable to the AED Plus unit and to the analyzer.
•
Turn on the analyzer and set its function to VF (ventricular fibrillation).
•
Variations in Messages
When verifying messages in the test results, please be aware of the following issues:
The wording of some messages is configurable. The following table shows equivalent
•
messages.
CHECK RESPONSIVENESS
CHECK CIRCULATION
IF NO CIRCULATION START CPR
IF NO CIRCULATION CONTINUE CPR
TREATMENT ADVISED
NO TREATMENT ADVISED
PRESS TREATMENT BUTTON
RELEASE TREATMENT BUTTON
TREATMENT DELIVERED
NO TREATMENT DELIVERED
The message that reports the detected electrode type can be either ADULT PADS or
•
PEDIATRIC PADS.
Some messages are issued only if the unit is configured to do so. If an optional message is
•
not issued during a test, do not consider this a failure.
In some cases a text message on the display screen is abbreviated or otherwise differs
•
slightly from the associated voice message.
1–4
T
ESTS
To verify that the delivered energy for the first, second, and third shocks corresponds
to the unit's preconfigured adult energy levels, use the ZOLL Administration Software
(ZAS) to obtain the current configuration of the unit.
www.zoll.com
CHECK PATIENT
CHECK PULSE
IF NO PULSE START CPR
IF NO PULSE CONTINUE CPR
SHOCK ADVISED
NO SHOCK ADVISED
PRESS SHOCK BUTTON
RELEASE SHOCK BUTTON
SHOCK DELIVERED
NO SHOCK DELIVERED
9650-0308-01 Rev. A