Smeg HOBD482D User Manual page 7

may damage the vitreous ceramic surface.
• Remove any melted plastic using a scraper pad
suitable for vitreous ceramic, while the cooker
hob is still hot. If you do not, the residue may
damage the vitreous ceramic surface.
• Remove limescale using a small amount of
limescale remover solution, for example vinegar
or lemon juice, once the cooker hob has cooled
down. Then clean again with a damp cloth.
4. REQUIREMENTS
FOR KITCHEN UNITS
• The cooker hob is designed to be fitted flush
with the kitchen worktop, on a kitchen unit
with a width of 600 mm or more.
• If the appliance is mounted on flammable
materials, the guidelines and regulations
relating to low voltage installations and fire
prevention must be followed strictly.
• For the fitted units, the components (plastic
materials and veneered wood) must be
mounted with heat-resistant adhesives (min.
100 °C): the use of unsuitable material
and adhesives may result in warping and
detachment.
• The kitchen unit must have sufficient space to
allow for electrical connection of the device.
Wall­mounted units above the device must be
installed at a sufficient distance to leave the
space required to work in comfort.
• The use of decorative hardwood borders
around the worktop behind the device is
allowed, provided the minimum distance
always complies with the indications provided
in the installation drawings.
• The minimum distance between the fitted
device and the rear wall is indicated in the
installation drawing for the flush-fitted device
(150 mm for the side wall, 40 mm for the rear
wall and 500 mm for any wall-mounted units
above it).
• To prevent infiltration of liquids between the
edge of the cooker hob and the worktop,
fit the adhesive seal supplied along the
whole outer edge of the cooker hob prior to
installation.
5. ELECTRICAL
CONNECTION
• Electrical connections must be carried out by
a trained technician.
• This appliance has a "Y" type connection, so
the power cable must have a "neutral" wire.
The power cable must be at least of type
H05VV­F. SINGLE PHASE, TWO PHASE and
THREE PHASE connection: min. cross­section
of wires: 2.5 mm² External diameter of the
power cable: min 7 mm - max 15 mm.
• The connection terminals can be accessed by
removing the junction box cover.
• Check that the domestic power supply
characteristics (voltage, maximum power and
current) are compatible with those of the
appliance.
• Connect the appliance as shown in the
diagram (in compliance with reference
standards in force nationally for mains
voltage).
• It is recommended that you use the
H05V2V2-F 5 x 2.5 mm² power cable.
When using the H05V2V2­F 5 x 2.5 mm²
power cable, follow the instructions provided
here: for three phase connection, separate the
2 wires and remove the blue sheathing from
the grey wires.
6. DISPOSAL
• The symbol on the product or on the
packing material indicates that the product
must not be treated as domestic waste; on
the contrary it must be sent to a collection
point that recycles electrical and electronic
appliances. Disposing of the product properly
will help avoid potentially negative effects to
the environment and to human health. For
further information on how to treat, recover
and recycle this product, please contact your
local waste disposal office, the domestic waste
disposal service or the shop from which you
purchased the product.
• The appliance complies with directive
2012/19/EU relating to reduction in the use
of dangerous substances in electrical and
electronic appliances and waste disposal.
29