1MAC254287-MB A
1.4.3
REM615 ANSI
Point List Manual
To save the changes in non-volatile memory, select Yes and press
•
Parameter names are shown in italics, for example:
The function can be enabled and disabled with the Operation setting.
•
Parameter values are indicated with quotation marks, for example:
The corresponding parameter values are "Enabled" and "Disabled".
•
IED input/output messages and monitored data names are shown in Courier font,
for example:
When the function picks up, the PICKUP output is set to TRUE.
•
Dimensions are provided both in inches and mm. If it is not specifically mentioned
then the dimension is in mm.
Functions, codes and symbols
Table 1:
Functions included in the REM615 standard configuration
Function
Protection
Three-phase non-directional time overcurrent
protection, low stage
Three-phase non-directional time overcurrent
protection, high stage 1
Circuit breaker failure protection
Loss of load protection
Phase reversal protection
Motor stall protection
Motor startup supervision
Three-phase thermal overload protection for motors
Negative phase-sequence time overcurrent
protection, stage 1
Negative phase-sequence time overcurrent
protection, stage 2
Three-phase undervoltage protection, stage 1
Positive sequence undervoltage protection
Ground overvoltage protection
Negative sequence overvoltage protection
Directional ground-fault protection – low stage
Ground non-directional time overcurrent protection,
low stage (Measured)
Arc flash detector 1
Arc flash detector 2
Arc flash detector 3
Table continues on next page
IEC 61850
IEC 60617
PHLPTOC1
3I>(1)
PHHPTOC1
3I>>(1)
CCBRBRF1
3I>/IoBF(1)
LOFLPTUC1
3I<
PREVPTOC1
I2>>
JAMPTOC1
Ist>
STTPMSU1
Is2t n<
MPTTR1
3Ith>M
MNSPTOC1
I2>M(1)
MNSPTOC2
I2>M(2)
PHPTUV1
3U<(1)
PSPTUV1
U1<
ROVPTOV1
U0>(1)
NSPTOV1
U2>
DEFLPDEF1
I
>->(1)
0
EFLPTOC1
I
>(1)
0
ARCSARC1
ARC(1)
ARCSARC2
ARC(2)
ARCSARC3
ARC(3)
Section 1
Introduction
.
ANSI
51P
50P-1
50BF
37
46R
51LR
66/51LRS
49M
46M-1
46M-2
27-1
27PS
59G
47
67/51N
51G
AFD-1
AFD-2
AFD-3
7