Setup Menu - Panasonic WJ-SX 150A Operating Instructions Manual

WJ-HD300 SERIES CONTROL (TERMINAL MODE)
Matrix switcher can control Digital Disk Recorder WJ-
HD300 Series. The following is the procedure of WJ-HD300
Series SETUP MENU.
Notes:
• The following operating procedures are for the terminal
mode. If you are using a PS·Data system controller,
refer to p. 36.
• When a Multiplexer board is installed in the matrix switch-
er, you can neither connect nor control a WJ-HD300 Series
recorder. You need to remove the board from the matrix
switcher.
■ Displaying WJ-HD300 Series

SETUP MENU

To display WJ-HD300 Series SETUP MENU, follow the pro-
cedure below.
1. Confirm that WJ-HD300 Series is correctly and securely
connected.
2. Select the desired monitor. (Refer to p. 3 Monitor
Selection.)
3. Enter the recorder mode. (Refer to p. 19 Recorder
Mode.) Then, the selected monitor number, recorder
number, and "/HD300" will appear on the LCD.
Mon4 Cam--
4. Press the MENU button repeatedly until "System Setup"
appears on the LCD.
System Setup
On
5. Press the F1 button.
System Setup
5On
WJ-HD300 Series SETUP MENU will appear on the
active monitor, and "B" mark will light up beside "On".
The following functions and buttons are valid in SETUP
MENU.
<Main unit>
JogDial clockwise: Increments a parameter.
JogDial counterclockwise: Decrements a parameter.
CAM (SET) button: Executes the selections and dis-
22
plays a submenu.
R4
/HD300
301
Off
301
Off
+ button: Increments a parameter.
– button: Decrements a parameter.
MON (ESC) button: Returns to SETUP MENU or the
previous menu.
<3D joystick unit>
3D joystick upward (D): Moves the cursor up.
3D joystick downward (C): Moves the cursor down.
3D joystick to the left (A): Moves the cursor to the left.
3D joystick to the right (B): Moves the cursor to the
right.
CLEAR button: Deletes a character when editing a
camera title, user ID, or password, etc.
6. To end the setting and return to the normal view, press
the F2 button when SETUP MENU is displayed. "B"
mark will disappear from the LCD.
■ Controlling Digital Disk
Recorder WJ-HD300 Series
The following are the operating procedures of WJ-HD300
Series via the system controller.
● Recorder Mode
The operations are the same as WJ-HD500 Series. (Refer to
p. 19.)
●
Multiscreen Segment Switching
The operations are the same as WJ-HD500 Series. (Refer to
p. 19.)
Note: The multiscreen segment patterns can be switched
as follows. (Applicable for WJ-HD316)
4 segments (1 - 4 CH) → 4 segments (5 - 8 CH) → 4
segments (9 - 12 CH) → 4 segments (13 - 16 CH) → 7
segments (1 - 7 CH) → 9 segments (1 - 9 CH) → 9 seg-
ments (10 -16 CH) → 10 segments (1 - 10 CH) → 13
segments (1 - 13 CH) → 16 segments (1 - 16 CH)