Connection With Digital Disk Recorder Wj-Hd100 Series Mux; (Panasonic Models) Mux - Panasonic WJ-SX 150A Operating Instructions Manual

Connection with Digital Disk Recorder WJ-HD100 Series
1. To record the camera images with Digital Disk Recorder WJ-HD100 Series, install an optional Multiplexer board in the
matrix switcher.
2. Connect the matrix switcher's EXT OUT (REC OUT) to the digital disk recorder's VIDEO IN with a coaxial cable.
3. Connect the matrix switcher's EXT IN (PLAY IN) to the digital disk recorder's MONITOR OUT (PLAY) with a coaxial cable.
4. Connect the matrix switcher's DATA HDR to the digital disk recorder's DATA with a modular cable.
5. Connect the matrix switcher's CAMERA SW IN to the digital disk recorder's CAMERA SW OUT with an RCA-pin cable.
6. Select "HD100" for 600 RECORDER in SETUP MENU. (Refer to p. 71.)
7. Conform the parameter of 740 CAMERA/DATA 1 - 4 PORT to the setting of the recorder.
The following parameters are fixed.
Data bit: 8 bits
Parity check: None
Stop bit: 1 bit
8 Conform the parameter of 620 RECORDER UNIT ADDRESS in SETUP MENU to the setting of the recorder. (Refer to the
recorder's operating instructions for the unit address.)
Note: After the connection, configure the system through SETUP MENU and WJ-SX150A Administrator Console.
Pin #13
(Recover Input)
DATA HDR Port
Matrix switcher's rear panel
DATA HDR
GND
RA
RB
45
Pin #10 (Alarm Out 1)
Pin #11 (Alarm Out 3)
Matrix Switcher
ALARM
DATA HDR DATA 4
TERM
OFF ON
PS•DATA
Pin #24 (Alarm Out 4)
Pin #23 (Alarm Out 2)
Pin #9 (GND)
IN
IN
OUT
OUT
CAMERA
MONITOR OUT
AUDIO VIDEO RS-232C DATA
SW OUT
(PLAY)
Recorder
ON
1 2 3 4 5 6
MODE
DATA HDR Port
TB
TA
RB
RA
GND
TB
TA
EXT IN 3 1
(PLAY IN)
SERIAL
CAMERA
RS485(CAMERA)
SW IN
DATA 3 DATA 2 DATA 1
LINE
SELECT
2 4
4 2
EXT OUT
RS485(CAMERA) MONITOR OUT
(REC OUT)
MODE REMOTE TIME SERIES ALARM
ADJUST RECORD
Set the recorder's alarm
polarity to Open-collector
low by setting the MODE
switch #6 to OFF.
Polarity switch
MUX
POWER
ON
SIGNAL GND
OFF